Welcome to Wiggyweb
Radio Communications via the Internet

RF gateways and links status.
Callsign  Frequency Ctcss On Air Off Air
GB3KB 50mhz Repeater 103.5  
GB3BK      23cm Repeater 103.5  
MB7ABR 70.4125 Simplex 103.5    
MB7IBR 144.9625 Simplex 103.5    
MB7ABR 430.050 Simplex 103.5    

Voip software to the above RF links.
Callsign Software Links On Air Off Air
GB3KB Echolink Link    
GB3KB Wires-X Link    
GB3KB CQ100 Link    
 
UiView32 aprs.
Callsign UiView32 RF Link Link On Air Off Air
GB3KB 144.800 Uiview32 Aprs    


Hardware.

Where shall I start, firstly I must thank Dave G7UZN, Dennis G0OLX and others for helping me to setup this project god knows how may paracetamol they swallowed.  

Below is the hardware that I use to Cross band links on Echolink, Wires-X and CQ100 (virtual radio), My Repeater links are on GB3KB 50.740, GB3BK 1299.850 and CQ100 29.510. My simlplex links are on 144.9625, 70.4125, 430.050. My room on Wires-X is user ID: GB3KB-RPT 34176, GB3KB-LINKS ID: 44176.

All links work simultaneously you don't need to make a connection to Echolink, Wires-X or CQ100 to cross band, you can use any of the links from RF to make a Echolink, Wires-X or CQ100 connection RF reports are always welcomed, Click Here

How it works all link radios are Motorola GM350s, GB3KB is a modified low band Philips FX-5000 which is coupled to the Scom 7330, Cat RLS-1000b and the Sigalink USB. When Echolink, Wires-X or CQ100 transmits or receives a signal this is passed to all radios connected to the interfaces above this works in all directions from all bands. Click Here to see how its hooked up.

 All links use CTCSS 103.5 for access, key down is set to 3 minutes and dead carrier and inactivity timeouts are set to 1 minute. 

APRS (UIiview32) is on 144.800 with Echolink this is used to provide information about my links which may be helpful to nearby stations trying to locate them. You can see my position Here

Click a pic to enlarge.

  A Drawing that shows how wiggylinks are interfaced to the radio's and software.
All links work simultaneously you don't need to make a connection to Echolink, Wires-X or CQ100 to cross band. Example: if you transmint on the 2m link then your audio is re-transmitted over 4m, 6m, 70cm, 23cm, Echolink, Wires-X and CQ100 and vice versa.
     
  CQ100 (virtual radio), CQ100 can be found on 29.510 and is connected to the system. You can download the 30 day trial version after registering, CQ100 is now free to use every Sunday (GMT). Vist site
     
  SignaLinkTM USB is used to conect CQ100 to the system, with a built-in low-noise USB Sound Card this ground breaking innovation delivers optimum performance while eliminating the need to attach to your computer's existing sound card. Convenient front panel controls and simplified installation. Visit site
     
  Yaesu Wires-X HRI-200 (Wide-coverage Internet Repeater Enhancement System) enables Internet to RF communications that expands the range of amateur radio using internet enabled Voice-over-IP technology. With Wires-X, an amateur node station connected to the Internet and Interfaced to the Wires-X HRI-200 unit can communicate using VoIP over long distances reliably with ease. Wires-X Acitive Nodes Click Here for Active Rooms Click Here or Visit Site
     
  Echolink software allows licensed Amateur Radio stations to communicate with one another over the Internet, using streaming-audio technology. The program allows worldwide connections to be made between stations. Echolink user Guide in PDF format can be downloaded Here or Visit site
     
  HAMSTIR-X is a VOIP crossband interface which allows Wires-X and EchoLink to commnicate with each other either by PC or RF operators. This system requires only one transceiver and one aerial. Visit Site
  The Ultimate linking interface (ULI) is the best i found to use with for Echolink, PSK31 or any other software that needs a soundcard. This interface is no longer available, this is the alternative. Visit Site
     
  Motorola GM350 more functions and programming options with the 128 channel  version, all links work simultaneously so you can use any of the links from RF to make a Echolink connection.
     
  GB3KB 6 meter repeater  the callsign is GB3KB, TX 50.740, RX 51.240, please use ctcss 103.5 for access. GB3KB is using a modified low band Philips FX-5000, RF reports are welcomed. Click Here
     
  GB3KB, The DPRE4-4(50) is a full-size duplex filter is made according to all the instructions for the manufacturing of such kind of equipment. An aluminum case is welded in to minimize the losses. The cavity is made of high-quality copper for ensuring the high selective properties (Q-factor). The regulating screw is made of invar for good thermal stability. Visit Site
     
  Scom 7330 3 port controller which is interfaced to the above Cat RLS-1000b, each port can be configured with independent settings, callsign, ctcss, timeout, etc etc, the functions of the controller in PDF format can be downloaded Here or Visit site
     
  Cat RLS-1000b Remote Link Switch's which is linked to the Scom 7330, functions of the controller in PDF format can be downloaded Here or Visit site
     
  GB3BK is made up using 2 Vhf GM340s mobile radios and a mini-kit transverter, housed in the Motorola XPR8300 Case. Mini-Kits Visit Site
     
  GB3BK, 23cms Bird Technologies manufacturers a comprehensive line of duplexers with the critical specifications you require to operate a high performance system. Visit Site
  UI-View32 is an APRS client this application differs from most APRS software in that it isn't designed just to be used with TNCs in terminal mode. Visit site or download the UI-View32 Quick-Start Guide in PDF format Here
  The AEA PK-232 gives you six modes including weather fax, Morse code, Baudot RTTY, ASCII, AMTOR and Packet. Two radio ports, HF/VHF radio selection switching on the front panel, indicators make multimode operation simple by giving mode and status information at a glance, operator's manual in PDF format can be downloaded Here
     
  RadioReference.com is the world's largest radio communications data provider, featuring a complete frequency database, trunked radio system information, and FCC license data. Listen live to Wiggylinks or Visit site
     
  For a map of my location on APRS (UiView) Click Here
     
  I use Webcam 7 with the IP Cameras below, this is a free server to monitor the Shack Cam and Garden Cams this will also alert you by email, to view my cams click this link Here or Visit Site
  My Shack and Garden IP Cameras, Some of the features wired or wireless, Standard H.264 video compression algorithm to satisfy the transmission of high definition video. 1/4" HD 1.0 megapixel lens COMS Sensor, maximum image resolution is up to 1280*720@25fps. Support P2P (point to point) technology, Video Push alarm,the IP Camera can be linked through the internet without any complicated port mapping, To view my Cams Click Here
     
  What keeps the above running, Windows 10 Pro.